User's Manual
Table Of Contents
- Front/Top View
- Back View
- Before collecting any data, configure your Mini HR for 2D or 3D data collection by pressingSystem Menu Options
- Date/Time: Configuring Date and Time
- Configuration: Configuring Orientation, Language, Units, Laser, and Sound
- The Mini HR will then shut down after calibration and will require a re-startClearing Storage: Deleting Saved Data
- Deleting All Projects or Deleting Specific Projects
- Scan Density: Selecting the Scan Density
- Backlight: Setting the Brightness of the Mini HR Backlight
- Save Prompt: Whenever Saving, Have the System Prompt You to Save or Save Automatically
- Collect Menu Options
- Project: Saving Files to a Specific Project
- Depth: Selecting the Depth Where You are Scanning
- Dielectric: Selecting the Approximate Dielectric of the Area You are Scanning
- Auto target: Allowing the Mini HR to Automatically Pick Your Targets
- Display: While Collecting Data, Display Data Only or Data + O-Scope
- Color: Choosing the Colors You Want Displayed During Data Collection
- Collecting Data and Marking Your Targets
- Playback Menu Options
- Project: Selecting a Specific Project to Select a Specific File to Playback
- Auto Depth: Automatically Adjusting Depth Scale
- Auto Target: Allowing the Mini HR to Automatically Pick Your Targets
- Auto Gain: Allowing the Mini HR to Automatically Configure the Gain
- Display: While Viewing Data, Display Data Only or Data + O-Scope
- Color: Choosing the Colors to Display during Data Collection
- Playing Back the Selected File
- Configuring the StructureScan Mini HR for 3D Collection
- Date/Time: Configuring Date and Time
- Configuration: Configuring Orientation, Language, Units, Laser, and Sound
- Calibration: Auto Calibrations for Surface and Brightness
- Clear Storage: Deleting Saved Data
- Deleting All Projects or Deleting Specific Projects
- Backlight: Setting the Brightness of the Mini HR Backlight
- Save Prompt: Whenever Saving, Have the System Prompt You to Save or Save Automatically
- Collecting 3D Data
- Collect Menu Options
- Collect: Collect 3D Grid
- Playback: Processing and Drawing the 3D Grid
- Modes
- Laser Information: General
- Laser Information: Specific for the StructureScan Mini HR
- Laser Information: Projected Laser Beam Layout
- Laser Information: Label Placement Diagrams
Quick Start Guide StructureScan Mini HR
Geophysical Survey Systems, Inc.
4
3 To power off the Mini HR, simply press and hold the power button for approximately 2 seconds. Then you may
remove the battery by pressing down on the tab of the battery and pulling down.
4 Note the buttons on the handle of the Mini HR.
They will be referred as Left ArrowÍ, Right Arrow
Î, Up Arrow Ï, Down Arrow Ð, and the Enter
buttons relative to the screen.
5 Depending upon the orientation of the screen on the
Mini HR (Left or Right depending upon which hand
you use), the Left, Right, Up, and Down buttons are
switched. However, you will still be pressing Í Î,
Ï, and Ð buttons, regardless of the orientation of
the screen. The Enter button (
) is located in the
center of the keypad. button
• At any time and unless otherwise noted, you
may press the Arrow button closest to the rear
of the Mini HR to return to the previous screen or menu.
This will be known as the “Back” button.
Unless otherwise noted, this button,
regardless of orientation, will return you to
the previous screen or menu.