User Manual
Table Of Contents
- Limited Warranty, Limitations Of Liability And Restrictions
- Garantie limitée, limites de responsabilité et restrictions
- FCC Notice (for U.S. Customers):
- (a) UWB imaging systems require coordination through the FCC before the equipment may be used. The operator shall comply with any constraints on equipment usage resulting from this coordination.
- Or
- Frequency Coordination Branch, OET
- ATTN: UWB Coordination
- Canadian Requirements for RSS-220
- Canadian Requirements of RSS-220 for Ground Antennas
- Canadian Requirements of RSS-220 for Hand-held Antennas
- Canadian Requirements of RSS-220 for Search and Rescue Antennas
- Table of Contents
- Section 1: Introduction 1
- StructureScan™ Mini XT 2
- Section 2: Getting Started 3
- Section 3: Using ScanEZ Mode 5
- Section 4: Using the Scan3D App 10
- Section 5: Using the ScanMax App 14
- Section 6: Calibrating for Depth in the ScanMax App 20
- Section 7: Using the DualScan App 23
- Section 8: File Management 26
- Setting up Your Laptop/PC and Data Transfer 27
- Launching and Navigating the Software 28
- Viewing and Processing the Data 30
- Processing the Data 32
- Ribbon Options 34
- Home Ribbon Options 34
- 3D Volume Options Ribbon 40
- Chapter 1: Using the StructureScan Mini XT
- Section 1: Introduction
- StructureScan™ Mini XT
- Section 2: Getting Started
- Section 3: Using ScanEZ Mode
- Section 4: Using the Scan3D App
- Section 5: Using the ScanMax App
- Section 6: Calibrating for Depth in the ScanMax App
- Section 7: Using the DualScan App
- Section 8: File Management
- Chapter 2: Using RADAN for StructureScan Mini
- Setting up Your Laptop/PC and Data Transfer
- Launching and Navigating the Software
- Viewing and Processing the Data
- Processing the Data
- Ribbon Options
- Home Ribbon Options
- 3D Volume Options Ribbon
- Appendix A: The Dielectric Constant
- Appendix B: Data Interpretation and Examples of Common Features
- Appendix C: Technical Specifications
- Appendix D: Accessories
- Appendix E: Labeling
Geophysical Survey Systems, Inc. StructureScan™ Mini XT
Manual
MN 70-813 Rev C 37
• Ground Truth: This will allow you to click on a target and enter the KNOWN DEPTH of that
target. This will adjust the scale accordingly. To use, click “Ground Truth” than use your mouse
cursor to left-click on something in the data. Usually this will be an embedded object, but a layer
such as back of slab works also. A box will then pop up and you will enter in the known depth to
that object.
Display Options
Color Tables: Change the color of your data.
Color Xforms: Change how the colors of your chosen color table are distributed.
Display Gain: Change the contrast (brightness) of your data. This changes the display only; it does not
change the actual data.
Targets: Turn the display of the targets (dots) on or off.
Export 2D
Targets: Export targets (dots) information (distance, depth) to a comma delimited ASCII file. The name
of the file is FileName+X.csv located in the output folder.
JPEG: Save the current file as a JPEG file (Picture File). This file will be named FileName+X.jpg located
in the output folder.
Excel: Create a report in Microsoft Excel with user entered information, data information and a picture of
the 3D Grid.
a) Enter information if needed. Click on OK
when done.
b) Open the Excel by clicking at the bottom of
the screen if it did not automatically open.
c) In Excel move the picture and adjust the size
of the picture as needed.
d) Print the report.