Installation Guide

Fig.1
INSTALLATION INSTRUCTIONS FOR P1302-L
For LED Semi-flush mount
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R
A V E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D O D I S J O N C T E U
ASSEMBLING THE FIXTURE (Fig.1)
1 Shut off power at the fuse box or circuit breaker. If necessary,
remove the old fixture including the mounting hardware.
2 Carefully remove the fixture from the carton and check that all
parts are included as show in Figure 1.
3 Thread the two screws (B) into the pre-drilled holes on the
crossbar (A) (Part#A-010) spaced the same distance apart as
the holes in canopy (E). Secure crossbar (A) to the junction
box using mounting screw(C) (Size: 8*32*1/2"L). The side of
the crossbar marked “GND” must face out.
4 Thread rod (G) onto nipple (S)
CONNECTING THE WIRES (Fig. 2)
5 Connect the electrical wire as shown in figure 3, making sure
that all wire connectors are secured. If your outlet has a ground
wire (green or bare copper), connect the ground wire from the
hanger ball and mounting plate to it. Otherwise connect fixture
ground wire directly to the crossbar using the green screw (D)
provided. Tuck the wire connections neatly into the ceiling
junction box as you hold the canopy towards the ceiling.
FINISHING THE INSTALLATION (Fig.1)
6 Align the canopy (E) onto screws (B) and secure with cap nuts
(F).
7 Thread rod (K) to joint (R). Align glass (I) to rod (K) and secure
with finial (J).
Your installation is now complete. Return power to the junction box
and test the fixture.
CAUTION/ATTENTION: When handling the fixture, do not apply
pressure to the LEDs. Hold the fixture by the base (H) only.
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician without
cutting of wire and without damage to any decorative element to
which the fixture is attached. See installation steps for more details
(Fig. 3)
Warning: Turn off power at the circuit breaker before replacing
LED module.
a. Loosen finial (J) and remove glass (I).
b. Loosen rod (R), screws (Q), rubber washer (N2) and remove
glass (P).
c. Loosen hexagonal stud (O), rubber washer (N1). Carefully
remove LED module (M) from pan (L) and disconnect the wire
using screwdriver from wire connector (Z).
d. Reverse steps a-c for installing the new LED module.
Note: The LED module should be provided by a specified supplier.
IMPORTANT: Fixture should be installed by a qualified electrician to
ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer
switches
Fig.2
Fig.3