Installation Guide

INSTALLATION INSTRUCTIONS
Item#P1355-618 (New. 10/28/2017)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.1
Fig. 2
LA-2876E
HANGING THE FIXTURE (Fig. 1)
1.
Carefully remove the fixture from the carton and check that all
parts are included as shown in the illustration.
2. Shut off power at the circuit breaker and remove the old fixture
including the mounting hardware.
3. Determine the desired hanging height and thread rods (F1, F2
and F3) to nipple (S) of the fixture body (M). Carefully pass the
wires through each rod during assembly. Secure swivels (G)
onto rods (F1).
4. Align canopy (H), metal plate (I) followed by lock washer (F) and
metal washer (E) onto swivels (G) and secure with hex nuts (D)
via wrench (J) included.
5.
Position the mounting plate (A) on the ceiling and mark the
location of the two drywall anchors (K). Pre-drill the holes for the
drywall anchors (K). Then insert t
he drywall anchors (K) into the
ceiling.
6. Attach mounting plate (A) to the outlet box using mounting
screws (B) (Size: #8-32N*L0.5”)
and wood screws (O) into
drywall anchors (K). The side of the mounting plate marked
“GND” must face out.
CONNECTING THE WIRES (Fig. 2)
7. At this point, c
onnect the electrical wires as shown in Fig. 2,
making sure that all wire connectors are secured. If your outlet
box
has a ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect the fixture’s
ground wire directly to the mounting plate using the green screw
provided. After wires are connected, tuck them carefully inside
the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
8. Align canopy (H) onto mounting plate (A) and secure with
screws (C).
9. Secure rod (N) onto the nipple (P) of the fixture body (M).
10. Install the 5*75W Xenon bulb (T) (included) in accordance with
the fixture’s specifications.
(DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!). (
NE PAS DEPASSER
LA PUISSANCE NOMINALE MAXIMALE!).
11. Place the glass shade (Q
) over the socket and twist to secure it
to the socket cup (L).
Your installation is now complete. Return power to the junction box
and test the fixture.
Note:
Illustration (Fig. 1) on this manual is for installation
purposes only. It m
ay or may not be identical to the fixture
purchased.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Rod#
W30-1-618*2(F1)
W30-1-618*4(F2)
W30-H-618*2(F3)
Set#
-
Mounting Plate
-
Ground Screw
-
Mounting Screw*2
Spanner#WRH-Y-89
K
A
O
D
E
F
C
I
H
G
J
B
F1
F2
F3
S
N
L
Q
M
P
T
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.