Installation Guide

INSTALLATION INSTRUCTIONS
(Rev. 05/10/2012)
READ AND SAVE THESE INSTRUCTIONS
WARNING ! SHUT P O WER OFF AT FU SE O R CI RC UI T BRE AK E R.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 2
Fig. 1
MOUNTING THE FIXTURE (Fig. 1)
1. Shut off power at the circuit breaker and remove old
fixture from wall, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Attach the Circular Strap (A) to the outlet box using
the two Screws (B). The side of the Circular Strap
marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
4. At this point, connect the electrical wire as shown in
Fig. 2, making sure that all wire connectors are
secured. If your outlet has a ground wire (green or
bare copper), connect the fixture’s Ground Wire to it.
Otherwise, connect the fixture’s Ground Wire directly
to the Circular Strap by using the Green Screw
provided.
FINISHING THE INSTALLATION (Fig. 1)
5. Place Fixture Body (D) over the Circular Strap (A),
then secure them tightly using two Screw Studs (C).
6. Install Xenon bulb into socket in accordance with the
fixture’s specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
7. Place glass shade (F) onto the socket, then secure it
by three pieces screws (E).
Your installation is now complete. Return power to the
outlet box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
LA-1186E
E
D
B
C
F
A
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.