Installation & Assembly

Page 2 of 2
Ax8 Bx8 Cx8 Dx1
STEP 1:
STEP 2:
Assembly is completed. The chair is ready to enjoy now!
Please find the package of Legs (2) and hardware on the top of the seat.
Then put the Chair Body (1) upside down on a carpeted or padded area by two adults to make the corners fully visible .
Position 1 piece of Front Leg (2) at one of the four wooden corners.
Insert 2 pieces of Spring Washer (B) and 2 pieces of Flat Washer (C) into 2 pieces of Bolts (
((
(A)
))
) as shown.
Then insert the assembled 2 pieces of Bolts (A) into the corner to connect the Front Leg (2).
Use Allen Wrench (D) to tighten the Bolts (A) clockwise until secure.
Repeat the same steps for 1 piece of Front Leg (2) and 2 pieces of Back Leg (3).
Hardware & Tool required
1
Carefully turn over the assembled Chair Body (1) as shown.
A
B
C
B
A
A
B
C
B
C
A
C
1
2
2
3
3
D
CHAIR