User's Manual
Table Of Contents
- Contents
- Note for Connecting to GV-DVR / NVR / VMS
- Note for Recording
- Note for Installing Camera Outdoor
- Optional Accessories
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Accessing the Live View
- Chapter 4 Administrator Mode
- Chapter 5 Face Recognition
- 5.1 Features
- 5.2 Installation Flowchart
- 5.3 Ideal Camera Position
- 5.4 Adjusting Illumination
- 5.4.1 Daytime
- 5.4.2 Nighttime
- 5.4.3 Low Illumination (WDR)
- 5.5 Enrolling Face Data
- 5.5.1 Photo Requirements
- 5.6 Face Recognition Basic Settings
- 5.6.1 Settings
- 5.6.2 License
- 5.6.3 Management
- 5.6.4 Events
- 5.6.4.1 Searching for log data
- 5.6.4.2 Enrolling Faces
- 5.6.4.3 Synchronizing Face Databases
- 5.6.5 Trigger Area
- Chapter 6 Recording and Playback
- Chapter 7 Advanced Applications
- Chapter 8 DVR / NVR / VMS Configurations
- Chapter 9 Smart Device Connection
- Appendix
Getting Started
2
B. Thread an Ethernet cable (the end with no RJ-45 connector) and the optional power
adapter wires from the back panel through the conduit connector.
Figure 1-11
IMPORTANT: Use the supplied ruler and leave about 14 cm of the Ethernet cable between
the connector the camera and the conduit connector. on
C. Re-install the cap. Make sure the cap is installed tightly to waterproof the camera.
6.
Tip: Unscr
ew the indicated screws and lift the camera to help you connect the wires and
Connect the wires to the camera. 1.5 Connecting the Camera and 1.6 I/O Connector.
i
nsert the memory card.
14