User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
Administrator Mode
3
3.3.2 Snapshot
Using the Snapshot function, when an alarm is triggered, the camera will automatically
upload the captured snapshots to the FTP server and/or send snapshots to the specified e-
mail addresses.
Note: If Upload Images is selected in Figure 3-49, 3.7.2 FTP, the captured snapshots will
only be sent to the FTP server.
Figure 3-15
1. Select On to enable Snapshot.
2. Select the Resolution.
3. Specify the maximum size (1~800 KB) of the snapshot image under Most Large.
4. Specify the length of interval (1~60 sec) between snapshots under Snapshot
Interval(s).
5. Choose the Number (of snapshot) to Snapshot upon alarm trigger.
6. Select Schedule or Repeat to set up the Snapshot Mode.
If you select Schedule, click
to specify the desired time to take a snapshot.
If you select Repeat, type the interval, from 1 to 86400 seconds, to repeat the
process of taking snapshots and sending them to the FTP server or e-mail.
7. Click Save.
99