User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
3.3.3 Audio
Note this function is only applicable to audio-supporting models.
You can configure the audio settings of the camera.
Figure 3-16
Audio Input: Select On to enable audio input.
Input Gain: Set the audio signal amplification for sampling. The greater the gain, the
greater amplification.
Audio Compression: Select an audio codec.
Noise Suppression: Select On to reduce the noise of the audio.
Channel 1 / 2: Click Enable to enable audio in through the camera’s built-in microphone
and/or Audio In wire(s) depending on the model.
Audio Output: Select the source of audio output.
Note: For GV-TDR2700 / 4700, connection(s) to any software/application must be
reestablished when its audio input channel has been alternated for the change to take effect.
100