User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
3.5.1.7 Face Detection
The Face function can detect for and capture face(s) in a specified area and send to an FTP
server. Select the checkbox next to Face to enable and click
to configure.
Figure 3-37
1. Once enabled, define the detection area, either by drawing a desired area on the image
or select Full Screen next to Specified Area to set the entire image as detection area.
2. Configure the following functions as needed:
Snapshot Sensitivity: Drag the slider to adjust the detection sensitivity.
Snapshot Mode: Select Intelligent Recognition to set the maximum of repeated
face snapshots (1~30) for Max. Same Thumbnail Image.
Min. Pupillary Distance (px): Click Draw and draw in the live view window.
Face Overlay: Enable to include the camera’s text overlay on the snapshot(s)
captured.
3. Under Trigger Actions, select Upload Image(Original) to upload a snapshot of the
entire image and a snapshot of the face detected upon face detection. Select Upload
Image(Target) to upload only the snapshot of the face detected.
4. For Plan, follow Step 6 in 3.5.1.1 Cross Line.
Note: The Counting and Counting Direction features are currently nonfunctional.
120