User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
3.5.1.9 Human Body Detection
Human Body Detection is used to generate an alarm whenever a human figure appears in
the specified area. Note this function is only applicable to GV-EBD4701 / 4712, GV-TBL4700
/ 4711, GV-TDR4703 series and GV-TVD4700 / 4711.
Figure 3-39
1. In the Snapshot Area, click
to add a new detection area.
2. Click and drag the detection area to a desired location.
3. You can adjust the detection sensitivity by dragging the Sensitivity slider.
[Alarm Parameters]
Suppress alarm: After a detection is triggered, the detection will not be reported within
the set time.
Clear alarm: After a detection is triggered,
If the detection is not triggered within the set time, the detection will be cleared and
the detection can be reported again.
If the detection is triggered within the set time, the detection will not be cleared until
the suppress alarm time expires. Then the detection can be reported again.
122