User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
3.6.2 Tampering Alarm
Note this function is only applicable to GV-EBD2702 / 4700 / 4711 / 8700 / 8711, GV-
ABL2702 / 2703 series / 4703 / 4712 / 8712, GV-ADR2702 / 4702, GV-AVD2700 / 4710 /
8710, GV-EBD4701 / 4712, GV-TBL2703 series / 4703 / 4700 / 4710 / 4711 / 8710, GV-
TDR2700 series / 2702 series / 4700 series / 4702 series / 4703 series and GV-TVD4700 /
4710 / 4711 / 8710.
Tampering alarm is used to detect when the camera is being physically tampered with. An
alarm can be generated when the camera is moved, covered up, or out of focus.
Figure 3-43
1. Select On to enable Tampering Alarm.
2. You can use the following functions to adjust the alarm settings.
Sensitivity: Move the slider to increase or decrease detection sensitivity.
Duration: Specify the duration of the alarm after which the triggered output device
will be turned off.
3. For Trigger Actions and Plan, follow Step 5 ~ 6, 3.5.1.1 Cross Line.
Note: The Alarm Output option (under Trigger Actions) is not supported by GV-EBD4701 /
4712, GV-TBL4700, and GV-TVD4700.
126