User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
3.7 Storage
This section allows you to configure storage related settings and set up FTP server.
3.7.1 Formatting Storage
Note this function is only applicable to GV-EBD2702 / 4701 / 4711 / 4712 / 8711, GV-
ABL2702 / 4712 / 8712, GV-AVD2700 / 4710 / 8710, GV-TBL4700 / 4710 / 8710, GV-
TDR2700 series / 4700 series / 4703 series and GV-TVD4700 / 4710 / 8710.
After inserting a memory card, you need to reboot the camera and refresh the Web interface.
You can configure the storage settings on the Storage page.
[Storage]
Figure 3-47
Storage Medium: Click the Format button to format the memory card before you start
recording and Enable the memory card.
[Allocate Capacity]
Figure 3-48
Video: Set the storage capacity used to store recorded videos. The remaining capacity
is used for captured snapshots.
Common Snapshot: The storage capacity used to store captured snapshots.
Face Snapshot: The storage capacity used to store captured face snapshots.
Note: Face Snapshot is not supported by GV-EBD4701 / 4712, GV-TBL4700 / 4711, GV-
TDR4703 series, and GV-TVD4700 / 4711.
130