User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
144
ngs
If for any reason the camera is not responding correctly, you can restore the camera back to
its factory default settings using the Web interface or the Default Button.
Note:
1. Only GV-EBD4711 / 4712 / 8711, GV-ABL2703 series / 4703, GV-AVD2700 / 4710 /
8710, GV-TBL2703 series / 4703 and GV-TVD4700 / 4710 / 4711 / 8710 support a
default button. For where the button is on the camera, see the Overview section in their
respective chapters.
2. If the default button doesn’t respond after pressing for 15 seconds, reboot the camera
and try again within 10 minutes of rebooting.
4.2 Restoring to Factory Default Setti
1. In the Web interface, click Setup.
2. In the left menu, select System and select Maintenance.
3. Under the Config Management section, click Default.
Figure 4-4