User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
DVR /NVR / VMS
5
5. Click
OK. The IP camera is added to the connection list.
6. Click the listed camera and select Display position to map the IP camera to a channel
on the GV-DVR / NVR.
Figure 5-4
7. The Statue column should display “Connected”. Click OK.
After the camera is connected and assigned with a display position, you can configure the
camera’s settings, such as frame rate, codec type and resolution. Right-click the desired
camera to see the following list of options:
Figure 5-5
Network Time Out: When network disconnection exceeds the specified time period, the
camera status displayed as Connection Lost.
On-Demand Display: Enable automatic switching between main stream and sub
stream based on the size of camera image on screen.
147