User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
8.
Thread the Ethernet cable through the PG21 conduit connector and the power box as
shown in No. 8, Figure 1-26. Then connect the cable to the camera. To waterproof the
cable, see 1.6 Waterproofing the Cable.
9. Rotate the plastic ring to secure the conduit connector to the power box. Screw in the
cap as shown in No. 9, Figure 1-26.
10. Screw the wall mount bracket to the power box as shown in No. 10, Figure 1-26.
Figure 1-26
11. Mount the bottom ring.
Figure 1-27
16