User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
1.4.3.2 GV-TVD4711
Figure 1-79
No. Description No. Description
1 Ethernet port 7 GND
2 Power port (2-Pin terminal block) 8 Digital Input
3 Micro SD card slot 9 GND
4 Default button 10 Audio In
5 Digital Output (N) 11 GND
6 Digital Output (P) 12 Audio Out
Note: There are two ways to supply power to the camera:
Use a Power over Ethernet (PoE) adapter to connect the camera to the network, and
the power will be provided at the same time.
Plug the power adapter to the supplied 2-pin terminal block by inserting the striped
wire to the right pin (-) and the black wire to the left pin (+), then insert the 2-pin
terminal block to Power Connector, No. 2.
Figure 1-80
58