User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
Introduction
1
1.
To install the power box from the wall mount bracket on the wall, follow steps 1 to 5 in
1.1.5.1 GV-Mount211P.
2. Unscrew the transparent dome cover with the supplied torx wrench.
Figure 1-88
3. Optionally insert a SD card into the slot.
4. Thread the camera cables through the bracket.
5. Secure the camera to the wall mount bracket with the provided short screws.
Figure 1-89
6. Thread the Ethernet cable through the PG21 conduit connector and the power box, as
shown in No 6, Figure 1-90. Then connect the cable to the camera.
7. Rotate the plastic ring to secure the conduit connector to the power box. Screw in the cap
shown in No 7, Figure 1-90.
8. Screw the wall mount bracket to the power box, as shown in No. 8, Figure 1-90.
Figure 1-90
65