User's Manual
Table Of Contents
- Preface
- Contents
- Naming Definition
- Note for Connecting to GV-VMS / DVR / NVR
- Note for Installing Camera Outdoor
- Note for Powering the Camera
- Note for Face Detection
- Note for People Counting
- Chapter 1 Introduction
- Chapter 2 Accessing the Camera
- Chapter 3 Administrator Mode
- Chapter 4 Advanced Applications
- Chapter 5 DVR / NVR / VMS
- Appendix
Introduction
1
1.
Paste the drill template to the ceiling and drill the ceiling to the size of the drill template.
2. Place the In-Ceiling Plate behind the ceiling with the flat side facing down.
3. Loosen the knob on the side of the camera and thread the camera wires through.
4. Thread the camera wires through the side of the In-Ceiling Mount Bracket and place the
camera in the Mount Bracket.
Figure 1-97
5. Open the transparent dome cover and insert the 3 M4 Screws (8 mm).
6. Align and secure the camera to the Mount Bracket with 3 M4 Screws (8 mm).
Figure 1-98
7. Connect the camera wires to the necessary wires.
8. Secure the housing cover, flip and hold the camera upside down against the ceiling.
9. Align and secure the Mount Bracket to the In-Ceiling Plate with 2 M4 Screws (40 mm).
Figure 1-99
10. Put on the In-Ceiling Cover to finish installation.
71