Manualshelf

User Manual

ManualsBrandsGeoVision ManualsAccess-Control KeypadsGeoVision GV-CS1320 2MP H.264 Camera Face Detection Access Controller with 180-degree panoramic lens and built-in 13.56 MHz Reader
21222324252627282930
Introduction
1
1.5.3 Replacing the Silica Gel Bag
If you opened the compartment cover at the back of your GV-CS1320 to change a new Micro
SD card, you must follow the steps below to replace the original silica gel bag with a new one.
1. Open the compartment cover at the back of your GV-CS1320 with a screwdriver.
Figure 1-10
2. To replace the silica gel bag, remove the silica gel bag and place a new one to the
camera.
Figure 1-11
3. Fasten the compartment cover.
Important:
1. The silica gel loses its effectiveness when the dry camera access controller is opened.
To prevent the lens from fogging up, replace the silica gel bag every time when you
open the camera access controller and conceal the gel bag in the camera access
controller within two minutes of exposing to the open air.
2. For each newly replaced silica gel bag, allow it to absorb moisture for at least 30
minutes before operating the camera.
13