User Manual

Remote Playback
49
6
Chapter 6 Remote Playback
The files backed up in the GV-Backup Center can be played back remotely using the GV-
Remote ViewLog. For the remote playback to work, ensure ViewLog Service on the
GV-Backup Center has been enabled.
Note: To remotely play back recordings, you can also use the Monitor Event List Query
page on the Web interface of GV-Backup Center. See 5.5 Monitor Event List Query.
To install and run the GV-Remote ViewLog, follow the steps below.
1. Go to the Software Download and Upgrading page of GeoVision Website:
http://www.geovision.com.tw/english/5_8_VMS.asp
.
2. Select the Video Management Software tab, find the Supplemental Utilities section
and click the Download icon
of GV-Remote ViewLog.
3. Run the GV-Remote ViewLog.
Note: When the Remote ViewLog program is started, it will pop up the selections of
Remote ViewLog Service and Remote Storage System. Just click any place on the window
to ignore and close the pop-up window.
To access recorded files from the GV-Backup Center through the Remote ViewLog program,
you can configure the Address Book for downloading the files of all connected IP devices, or
connect through the Remote ViewLog Service for downloading the files of a specific IP
device. For quick access to the recorded files of a specific IP device, it is recommended to
connect through the Remote ViewLog Service.