User Manual

Center V2 1
1.5.2 Setting Panic Button
You may set up a panic alarm button at your GV-System / GV-VMS. In case
of emergency, press the button immediately to send the associated video
to Center V2.
To set up a panic alarm, select Panic Button from the Mode drop-down list
in the Connect to Center V2 dialog box (Figure 1-10), click the Configure
button and select Advanced Settings. This dialog box appears.
Figure 1-17
[Panic Button] Assigns an input device to be the panic alarm button.
 Trigger by I/O: Assigns an input module and a pin number.
 Output Module: Enables an assigned output module when the panic
button is pressed.
For the example of Figure 1-17, when the panic button (Module 1, Pin
1) is pressed, the output module (Module 3, Pin 4) will be triggered
simultaneously.
[Send which Camera(s) to Center V2] Select which camera video should
be sent to Center V2 when the panic alarm button is pressed.
33