User Manual

206
ct User-defined and select Define
an
for User-defined and click Set
rag an area on the image. This
ral areas with
rag an area on the
image.
ce and use the slider
ideo noise.
want to ignore environmental changes such as rain or snow, select Ignore environmental
9. To set minimum time for motions to be counted as motion detection, select Minimum duration
and specify the minimum number of seconds motions must exceed (Max. 60 seconds),
10. Click OK to save your settings.
Note:
1. This feature must work with the recording mode of Motion Detection: click the Configure button
(No. 14, Figure 1-2), point to System Configure, select Camera Configure, check Rec Video,
and then select Motion Detect (Figure 1-9).
2. If you have set up Motion Sensitivity and Mask Filter in the Camera Configure settings (Figure
1-10), note that the configurations of Advanced Motion Detection have priority over these
settings.
3. When Ignore environmental changes is selected, objects moving steadily and repeatedly in
the same direction for over 1.5 seconds will be filtered out and ignored.
4. To limit motion detection to objects within a size range, sele
Object. Select Min. Object Size or Max. Object Size from the drop-down list and then drag
area on the image.
5. To set detection sensitivity in a specific area, clear the selection
region. Select a sensitivity level by moving the slider, and then d
setup has sensitivity levels from 1 to 5, with 4 as default. You can create seve
different sensitivity levels.
6. If you want to ignore motion in a certain area, click Mask Region, and then d
7. If you want to ignore video noise when light changes, select Noise Toleran
to adjust the level. The higher the level, the more tolerant the system is to v
8. If you
changes.