User Manual

150
2. Click
for the PTZ setup. Refer to Object Tracking earlier in this chapter.
3. Choose the camera view of the PTZ. In Figure 3-9, the images of the PTZ camera show in the
hen click the Add
in the upper-left corner of the right image.
camera 2 view.
4. Use the sliders of Pan, Tilt and Zoom to set up the View 1 as shown below. T
button to apply the settings. The View 1 will show
Figure 3-10
5. Click the drop-down menu to set up View 2, 3, and 4, one at a time. Refer to Step 4.
6. S uration in seconds. pecify Idle Time (sec), indicating the zooming d
, View 1, View
racking and Refresh View.
next zooming
 Tracking: After the idle time, the PTZ camera will start tracking if it is also being applied for
3, 4: After the idle time, the PTZ camera will go back to the preset View 1, 2, 3, or
8. Click Schedule to set a schedule to enable the function. For details, see Video Analysis Schedule
later in this chapter.
9. Click Test to check your settings. Use the mouse to outline a desired area in one of the four views.
The area will be magnified in the left view.
10. Click OK to apply the displayed selections and close the dialog box.
Figure 3-11
7. Click the Idle Mode drop-down menu. The seven options included inside are: None
2, View 3, View 4, T
 None: After zooming, the PTZ camera will remain on the same view until the
command.
the tracking function.
 View 1, 2,
4.
 Refresh View: After the idle time, the 4 views will be refreshed.