User Manual

546
on top: This option makes the LED panel stay on top of other
 Synchronize the LED Panel with the LED Device on GV-Hot Swap DVR: This option is
designed for the use of the GV-Hot Swap DVR System. When this option is enabled, the
LED device installed on the front panel of the GV-Hot Swap DVR System will synchronize
with the LED panel on the screen.
 Enable disk full beep: When the hard disk drive is full, the system sounds on. Note this
function only works wh quipped or installed with a PC speaker.
default, only the eo and audio files will be assigned to LED. If you
ant to re-assign th e or assign other drives to LEDs, freely move the hard disk
desired
to apply the settings, an dia Man Tool window to display the LED panel
on the screen.
4. If you want to return to the Media Man Tools window, right-click the LED panel and select Switch
to the setup window.
Note:
1. Because the LEDs are designed to indicate the video and audio files are being written or read, it
is not recommended to assign the HDDs that store log files to the LEDs.
2. If the HDD that stores log files is assigned to a LED and its LED turns red, make sure the log
files are not being written before you remove it. Otherwise, the log files might be lost during the
removal. For details on storage locations of logs and video/audio files, see Setting Data Storage
in Chapter 1.
 LED Panel always stays
windows when the Media Man Tools window is minimized.
en the motherboard is e
2. By hard disk drive that stores vid
w e hard disk driv
drive to the LED on the tree.
3. Click OK d minimize the Me