User Manual

Center V2 1
Note:
1. T
o set an input trigger for the notification of Normal events, see
[Security Service] below.
2. The delay settings in Send to Center V2 when I/O is triggered
and Output Module allow you to enter your premises and disable
input/output module before it is activated.
To disable prior I/O settings, the subscriber may exit the
connection to Center V2 or use the Stop monitoring normal
events when selected pin is triggered feature in Figure 1-14.
 Allow Center V2 to Force Output: Allows Center V2 to manually
force output devices of the subscriber to be triggered.
[Security Service] Defines the input type or the schedule. Proceed to
configure input and schedule settings.
 Momentary Mode: Pushbutton switches that are normally open and
stay closed only as long as the button is pressed. Momentary
switches allow turn-on or turn-off from multiple locations.
For example, certain premises have a designated entry/exit door.
When the staff enters the entry door, the system starts monitoring.
When the staff leaves from the exit door, the system stops monitoring.
 Maintained Mode: Push-on/push off button switches that stay open
until thrown, and then stay closed until thrown again. Maintained
switches are convenient for only one switch location.
For example, in the business hour when the door is opened, the
system stops monitoring; in the non-business hour when the door is
closed, the system starts monitoring.
31