Installation Manual

Option 2: Magnet Clasp Detection Sensor
To connect the Magnet Clasp Detection Sensor to the GV-AS410, connect one wire from NC
of the electromagnetic lock’s circuit board to the Input of the GV-AS410, and connect the
other wire from COM of the electromagnetic lock’s circuit board to the Ground of the GV-
AS410.
Note: The two wires mentioned in Option 2 are not included in the package; the users
must prepare them additionally. It is recommended to use wire No. 26 AWG (American
Wire Gauge) or above.
June 3, 2015
8