Data Sheet

Table Of Contents
Installing the Vandal Proof IP Dome (Part II)
3
1. Assemble the mounting bracket (GV-Mount101, No. 1), tube (GV-Mount101, No. 2), tube
connector (GV-Mount101, No. 3), housing cap (GV-Mount903, No. 2) and the dome
housing (GV-Mount903, No. 1) with M6 screws (GV-Mount903, No. 4).
2. Thread the power (supplied), network (self-prepared) and other wires (supplied) through
the box cover and into the dome housing.
3. Secure the supplied back plate to the dome housing.
4. Thread the wires into the camera. See steps 1 to 3 in Installation, Vandal Proof IP Dome
(Part II) Chapter, GV-IPCam H.264 Hardware Manual - VD on the software DVD.
5. Secure the camera to the back plate with the supplied torx wrench.
6. Connect the camera wires with the wires from the ceiling
99