Data Sheet

Table Of Contents
Installing the Target Vandal Proof IP Dome
14
3. Insert the wall mount screws (GV-Mount900, No. 3) and leave enough distance
(approximately 2 mm) to hang the wall mount bracket later.
Wall
2 mm
Long
Screw
4. Open the camera housing cover, remove the back plate and thread the cables into the
camera. See steps 1 to 6 in Installation, Target Vandal Proof IP Dome Chapter, GV-
IPCam H.264 Hardware Manual - EVD on the software DVD.
5. Align and secure the back plate with the L-shaped mount with four M5 screws
(GVMount900, No. 5). Use the holes labeled as VD.
6. Secure the camera to the back plate with the supplied torx wrench.
7. Hang the wall mount bracket on the wall mount screws and push the wall mount bracket
downward. Tighten the wall mount screws to the wall.
349