User Manual

20
1.3.2 Setting Recording Settings for Individual Cameras
In the lower half of the Record Setting dialog box, you can select a camera and configure the recording
mode and video storage location for the selected camera(s) only.
Figure 1-14
1. Select the camera you want to configure. Hold the Shift key to select multiple cameras if needed.
2. Under Record Type, select Round-the-clock or Motion Detect.
3. Click the Arrow button
next to Storage to specify where to store the recorded videos. For
details, see Setting Up the Video Storage Location later in this section.
4. You can set different recording frame rates for motion and non-motion recordings. In
Round-the-Clock mode, the camera will use the frame rate setting in 4a for non-motion events and
4b for motion events. For Motion Detection recording mode, the frame rate setting in 4b will be
used.
a. Define non-motion events as General or Urgent Event under Video Record Frame Rate.
b. For motion events, click the arrow button
next to Record Type and define motion events
as General or Urgent Event under Video Record Frame Rate.
The frame rate for General Event and Urgent Event can be defined in the camera’s General
Setting dialog box (Figure 2-11). Normally, you would set a higher frame rate for Urgent Events
(Ex: full frame) and a lower frame rate for General Events (Ex: key frame only).
Note:
1. Refer to Configuring General Settings in Chapter 2 for setting the frame rate for General Event
and Urgent Event.
2. For details on other motion detection settings, refer to Setting Up Motion Detection later in this
section.