Quick Start Guide
Table Of Contents
- Contents
- Important Note for Maintaining Power Supply
- GV-AS Controller Quick Start Guide
- 1. Basic Setup for GV-AS100 / 1010 / 110 / 1110 / 120
- 2. Physical Wiring for GV-AS210 / 2110 / 2120 / 410 / 4110 / 810 / 8110 and GV-EV48
- 3. Accessing the Web Interface of the GV-AS Controllers
- 4. Setting GV-AS Controller on GV-ASManager
- 5. Optional Devices for GV-AS100 / 110 / 120
October 29, 2015
9
4. Setting GV-AS Controller on GV-ASManager
After setting up the Web interface, connect the GV-AS Controller to a GV-ASManager.
Through GV-ASManager, you can set up the doors and enroll cards. The section numbers
listed here refers to the GV-ASManager User Manual.
Install GV-ASManager
Install GV-ASManager from the supplied
software DVD.
Chapter 2 Installation
Set GV-AS Controllers
Establish connection between the controllers
and GV-ASManager.
4.2.1 Configuring a Controller
Set doors / gates
Enable the doors on the controllers and
configure settings as needed.
4.2.2 Configuring a Door
Add cards to GV-ASManager
Enroll cards into GV-ASManager and define the
card types.
4.3 Adding Cards