Quick Start Guide
Table Of Contents
- Caution
- Safety Notice
- Options
- Note for Adjusting Focus and Zoom
- Note for Installing Camera Outdoor
- Note for Closing the Bullet Camera Cover
- Note for Silica Gel Bags
- Note for Waterproofing Failures
- Note for Recording
- Chapter 1 Bullet Camera (Part I)
- Chapter 2 Bullet Camera (Part II)
- Chapter 3 Bullet Camera (Part III)
- Chapter 4 Ultra Bullet Camera
- Chapter 5 Target Bullet Camera (Part I)
- Chapter 6 Target Bullet Camera (Part II)
- Chapter 7 Target Bullet Camera (Part III)
- Chapter 8 Accessing the Camera
- Chapter 9 The Web Interface
- Chapter 10 Upgrading System Firmware
Target Bullet Camera (Part II)
6
3
. Secure the camera cover.
4. Slide the sun-shield cover onto the top of the camera. You can also
secure the sun shield cover onto the back of the camera. Adjust the
position of the cover before fully securing the cover with the washer
and the screw.
Figure 6-7
Note:
1. The GeoVision logo on the sun-shield cover should be closer to
the front of the camera.
2. There are two holes for the screws at the back of the camera.
You only need to fasten one screw to secure the sun shield
cover.
87