Quick Start Guide
Table Of Contents
- Caution
- Safety Notice
- Options
- Note for Adjusting Focus and Zoom
- Note for Installing Camera Outdoor
- Note for Closing the Bullet Camera Cover
- Note for Silica Gel Bags
- Note for Waterproofing Failures
- Note for Recording
- Chapter 1 Bullet Camera (Part I)
- Chapter 2 Bullet Camera (Part II)
- Chapter 3 Bullet Camera (Part III)
- Chapter 4 Ultra Bullet Camera
- Chapter 5 Target Bullet Camera (Part I)
- Chapter 6 Target Bullet Camera (Part II)
- Chapter 7 Target Bullet Camera (Part III)
- Chapter 8 Accessing the Camera
- Chapter 9 The Web Interface
- Chapter 10 Upgrading System Firmware
Accessing the Camera
8
8.2.2 Configuring the IP Address
Follow the steps below to configure the IP address.
1. Open your Web browser, and type the default IP address
http://192.168.0.10
.
2. In both Login and Password fields, type the default value admin.
Click Apply.
3. In the left menu, select Network and then LAN to begin the network
settings.
Figure 8-4
4. Select Static IP address, Dynamic IP address or PPPoE and type
the required network information.
5. Click Apply. The camera is now accessible by entering the
assigned IP address on the Web browser.
6. To enable the updating of images in Microsoft Internet Explorer, you
must set your browser to allow ActiveX Controls and perform a one-
time installation of GeoVision’s ActiveX component onto your
computer.
105