Quick Start Guide
Table Of Contents
- Caution
- Safety Notice
- Options
- Note for Adjusting Focus and Zoom
- Note for Installing Camera Outdoor
- Note for Closing the Bullet Camera Cover
- Note for Silica Gel Bags
- Note for Waterproofing Failures
- Note for Recording
- Chapter 1 Bullet Camera (Part I)
- Chapter 2 Bullet Camera (Part II)
- Chapter 3 Bullet Camera (Part III)
- Chapter 4 Ultra Bullet Camera
- Chapter 5 Target Bullet Camera (Part I)
- Chapter 6 Target Bullet Camera (Part II)
- Chapter 7 Target Bullet Camera (Part III)
- Chapter 8 Accessing the Camera
- Chapter 9 The Web Interface
- Chapter 10 Upgrading System Firmware
Bullet Camera (Part I)
1
S
econd Shaft
You can adjust the camera body up and down by 90, 112.5, 135, 157.5 or
180 degrees by using the gears inside the camera body and the camera
base.
1. Unscrew the tilting lock screw with the torx wrench.
Torx Wrench
Tilting Lock Screw
Figure 1-12
2. Hold the camera body, and move the camera base to the right to
separate the camera gears.
Camera Body
Camera Gears
Move the Camera
Base to the Right
Figure 1-13
13