Quick Start Guide

Bullet Camera (Part II)
2
B
. Thread an Ethernet cable (with no RJ-45 connector on one end)
from the back panel through the conduit converter (optionally
installed at step 6) and then through the cable seal.
Figure 2-11
IMPORTANT: Use the supplied ruler and leave about 10 cm of the
Ethernet cable between the connector and the cable seal.
C. Re-install the cable seal. Make sure it is installed tightly to
waterproof the camera.
8. Thread wires into the camera.
A. Disintegrate the removed conduit connector. You should have 4
parts:
1 2
3 4
Figure 2-12
33