Quick Start Guide
Table Of Contents
- Caution
- Safety Notice
- Options
- Note for Adjusting Focus and Zoom
- Note for Installing Camera Outdoor
- Note for Closing the Bullet Camera Cover
- Note for Silica Gel Bags
- Note for Waterproofing Failures
- Note for Recording
- Chapter 1 Bullet Camera (Part I)
- Chapter 2 Bullet Camera (Part II)
- Chapter 3 Bullet Camera (Part III)
- Chapter 4 Ultra Bullet Camera
- Chapter 5 Target Bullet Camera (Part I)
- Chapter 6 Target Bullet Camera (Part II)
- Chapter 7 Target Bullet Camera (Part III)
- Chapter 8 Accessing the Camera
- Chapter 9 The Web Interface
- Chapter 10 Upgrading System Firmware
Bullet Camera (Part III)
3
3.3 Installation
You can install the camera to the ceiling or wall. Follow the steps below.
1. Unscrew the camera body, remove the sun-shield mount, and
loosen the camera cover from the camera.
Screws
Sun-Shield Mount
Camera Cover
Figure 3-2
2. Insert a micro SD card (SD/SDHC/SDXC/UHS-I, Class 10) into the
card slot.
3. Tape two silica gel bags to the camera module.
Silica Gel Bag
Micro SD Card
Figure 3-3
43