Quick Start Guide
Table Of Contents
- Caution
- Safety Notice
- Options
- Note for Adjusting Focus and Zoom
- Note for Installing Camera Outdoor
- Note for Closing the Bullet Camera Cover
- Note for Silica Gel Bags
- Note for Waterproofing Failures
- Note for Recording
- Chapter 1 Bullet Camera (Part I)
- Chapter 2 Bullet Camera (Part II)
- Chapter 3 Bullet Camera (Part III)
- Chapter 4 Ultra Bullet Camera
- Chapter 5 Target Bullet Camera (Part I)
- Chapter 6 Target Bullet Camera (Part II)
- Chapter 7 Target Bullet Camera (Part III)
- Chapter 8 Accessing the Camera
- Chapter 9 The Web Interface
- Chapter 10 Upgrading System Firmware
4.3 Installation
You can install the camera to the ceiling or wall. Follow the steps below.
1. Optionally insert a micro SD card to the camera.
A. Unscrew and open the back panel with the supplied torx wrench.
Figure 4-2
B. Insert a micro SD card into the card slot and replace the silica
gel bag (see Figure 4-1).
IMPORTANT: Make sure the I/O connector is firmly plugged.
C. Secure the back cover with the supplied torx wrench.
2. Install the sun-shield cover to the camera.
60