Quick Start Guide
Table Of Contents
- Caution
- Safety Notice
- Options
- Note for Adjusting Focus and Zoom
- Note for Installing Camera Outdoor
- Note for Closing the Bullet Camera Cover
- Note for Silica Gel Bags
- Note for Waterproofing Failures
- Note for Recording
- Chapter 1 Bullet Camera (Part I)
- Chapter 2 Bullet Camera (Part II)
- Chapter 3 Bullet Camera (Part III)
- Chapter 4 Ultra Bullet Camera
- Chapter 5 Target Bullet Camera (Part I)
- Chapter 6 Target Bullet Camera (Part II)
- Chapter 7 Target Bullet Camera (Part III)
- Chapter 8 Accessing the Camera
- Chapter 9 The Web Interface
- Chapter 10 Upgrading System Firmware
Bullet Camera (Part III)
4
Volt
age Load Expansion (Optional)
The camera can only drive a maximum load of 200mA 5V DC. To expand
the maximum voltage load to 10A 250V AC, 10A 125V AC or 5A 100V DC,
connect the camera to a GV-Relay V2 module (optional product). Refer to
the figure and table below.
Output Devices
Connect
to power
Figure 4-16
GV-Relay V2 Ultra Bullet Camera
DO1 Digital Out (Blue)
COM Ground (Black)
69