Quick Start Guide
Table Of Contents
- Caution
- Safety Notice
- Options
- Note for Adjusting Focus and Zoom
- Note for Installing Camera Outdoor
- Note for Closing the Bullet Camera Cover
- Note for Silica Gel Bags
- Note for Waterproofing Failures
- Note for Recording
- Chapter 1 Bullet Camera (Part I)
- Chapter 2 Bullet Camera (Part II)
- Chapter 3 Bullet Camera (Part III)
- Chapter 4 Ultra Bullet Camera
- Chapter 5 Target Bullet Camera (Part I)
- Chapter 6 Target Bullet Camera (Part II)
- Chapter 7 Target Bullet Camera (Part III)
- Chapter 8 Accessing the Camera
- Chapter 9 The Web Interface
- Chapter 10 Upgrading System Firmware
5.3 Installation
You can install the camera to the ceiling or wall. Follow the steps below.
1. Slide the sun-shield cover onto the top of the camera.
Figure 5-3
Note: The GeoVision logo on the sun-shield cover should be closer to
the front of the camera.
2. Line up the screw hole on the camera with the opening on the sun-
shield cover.
Figure 5-4
74