User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
84
4.2.5 Connecting the Power
For GV-AS210 / 2110, you can connect the controller to power directly using the supplied
12V DC adaptor. For GV-AS2120, you can choose to supply power using a power adaptor
(available for separate purchase) or using a Power over Ethernet (PoE) adapter. After power
is connected, the power LED on GV-AS210 / 2110 / 2120 should glow.
Note: Power should be applied to the unit when all connections are completed and tested.
GV-AS210 / 2110: Use the supplied power adapter.
Power Jack
1
2
3
Power
Source
12V DC / 3A
power adaptor
Power LED
GV-AS210 /
GV-AS2110
Figure 4-8