User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
GV-AS210 / 2110 / 2120 Controller
85
4
GV-AS2120: Connect a PoE adapter or a 12V DC / 3A power adapter (not included). When
using PoE:
z The Ethernet cable must be Cat 5e or above.
z The maximum power consumption supported is 25.5 W. You will need to connect an
external power supply if the total power consumption exceeds 25.5 W after output
devices and readers are connected.
Power Jack
1
2
3
Power
Source
12V DC / 3A
power adaptor
Power LED
GV-AS2120
Ethernet
PoE Adapter
Figure 4-9
Note: To calculate the total power consumption, add the power consumption of the
controller, output devices and readers connected. For example, if you connect 4 GV-EL202B
and 8 GV-DFR1352 to the GV-AS2120, the total power consumption will be 25.16 W.
z Each GV-EL202B uses 3.6 W * 4 = 14.4
W
z Each GV
-DFR1352 uses 0.72 W * 8 = 5.76 W
z GV-AS2120 uses 5 W
Total power consumption: 14.4 + 5.76 + 5 = 25.16 W