User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
GV-AS210 / 2110 / 2120 Controller
87
4
4.2.7 Fitting the Battery (GV-AS2110 / 2120 Only)
GV-AS2110 / 2120 includes a replaceable cell button battery. When the power in the battery
becomes low, a “Low Battery” message and icon will appear in GV-ASManager. When this
happens, replace the battery. All settings on GV-AS2110 / 2120 will disappear about 10
hours after the battery stops working, and GV-AS2110 / 2120 will be restored to default
settings.
GV-AS2110 / 2120
Power
Jack
+
_
RTC Battery
(Only available in
GV-AS2110 / 2120)
Figure 4-11
Note:
1. Make sure the plastic insulation film under the battery is removed.
2. It is recommended to replace the battery annually.