User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
88
4.3 Other Settings
4.3.1 Web Setting Switch
When the Web Setting switch is set to the ON position, you can modify Advanced Settings
and Extended Reader of GV-AS210 / 2110 / 2120 through its Web interfaces. When the
switch is set to the OFF position, Advanced Settings are not accessible. For details on
Advanced Settings, see 8.2 Advanced Settings.
Wiegand B
Wiegand A
Web Setting
Switch
ON OFF
OFF
ON
Figure 4-12
4.3.2 Resetting the Controller
To reset GV-AS210 / 2110 / 2120, press the Reset button in the bottom half of GV-AS210 /
2110 / 2120 circuit board for three seconds.
Wiegand
Reset
Button
Wiegand Wiegand
Figure 4-13