User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
GV-AS210 / 2110 / 2120 Controller
89
4
4.3.3 Restoring Factory Defaults
To restore GV-AS210 / 2110 / 2120 to factory default settings, press the Default button for
10 seconds.
NC2
COM2
NO2
NC1
COM1
NO1
Power Jack
Load Default Button
GV-AS210 / 2110
NC4
COM4
NO4
NC3
COM3
NO3
Figure 4-14
Micro
SD
Default
ON
OFF
12V
D0
D1
GND
12V
D0
D1
GND
12V
D0
D1
GND
RS-485_A TERM
RS-485_B TERM
A+
A-
B+
B-
Load Default Button
GV-AS2120
Figure 4-15