User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
GV-AS410 / 4110 / 810 / 8110 Controller
93
5
5.1 Introduction
5.1.1 Main Features
GV-AS410 / 4110
• One-way control: 4 doors
• Two-way control: 4 doors
• Support 8 Wiegand card readers of 26 to 64 bits
• Support 8 GV-Readers / GV-GF Fingerprint Readers through RS485 connection /
Network
• Built-in 16 digital inputs and 24 relay outputs
• Suitable for doors, parking gates and access to elevator call buttons
• Support for tampering alarm
GV-AS810 / 8110
• One-way control: 8 doors
• Two-way control: 4 doors by Wiegand only, 8 doors by Wiegand / RS-485 / Network
• Support 8 Wiegand card readers of 26 to 64 bits
• Support 16 GV-Readers / GV-GF Fingerprint Readers through RS485 connection /
Network
• Built-in 16 digital inputs and 24 relay outputs
• Suitable for doors, parking gates and access to elevator call buttons
• Support for tampering alarm