User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
98
Note:
1. Each set of 12V power output and GND can provide power for up to 2 readers. The 3
sets on the power terminal can support up to 6 readers. If you wish to connect more
readers and the Wiegand interfaces are already occupied, you can connect the
readers to external power source.
2. By default, a jumper cap is installed on the RS485_A Terminal Resister (J37) to
ensure stability when the RS-485 connection between GV-AS410 / 4110 / 810 / 8110
and the reader is over a long distance.
3. Although up to 8 RS-485 readers can be connected, GV-AS410 / 4110 only supports
control of up to 4 doors.