User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
GV-AS410 / 4110 / 810 / 8110 Controller
101
5
5.2.4 Connecting Backup Battery
You can connect any 12V battery to GV-AS410 / 4110 / 810 / 8110 to provide backup power
when the main power supply fails. When the main power supply is removed and the battery
voltage level is above 10.2V, the Discharging LED will light and the battery will support
normal operation of the GV-AS410 / 4110 / 810 / 8110.
12V
Battery
Black
Red
(BAT)
- +
12V OUTPUT
12V
GND
12V
GND
12V
GND
CON9
SW1
Figure 5-6
5.2.5 Connecting the Power
You can connect GV-AS410 / 4110 / 810 / 8110 to power directly using the supplied 12V DC
adaptor. After power is connected, the power LED on GV-AS410 / 810 should glow.
Note: Power should only be applied to the unit when all connections are completed and
tested.
Power LED
GND
IN04
IN03
GND
IN02
IN01
(BAT)
- +
SW1
Power
Source
12V DC
power adaptor
Figure 5-7