User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
102
5.2.6 Connecting the PC
Connecting GV-AS410 / 4110 / 810 / 8110 to a computer allows you to access its Web
interface and connect it to GV-ASManager if the computer is installed with GV-ASManager.
The computer running GV-ASManager software can be used to monitor the access
information and alarm messages from GV-AS410 / 4110 / 810 / 8110. If connection with GV-
ASManager is interrupted, GV-AS410 / 4110 / 810 / 8110 stores this information on the
supplied micro SD card. The data stored will be sent to GV-ASManager when connection
resumes.
Network
PC
GV-AS410 / 4110 /
810 / 8110
Micro SD
Ethernet
GND
IN16
IN15
GND
IN14
IN13
Figure 5-8
Note: GV-AS410 / 810 is only compatible with GV-ASManager V4.0 or later, and GV-AS4110
/ 8110 is only compatible with GV-ASManager V4.2.3 or later.