User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
GV-EV48 Controller
113
=
6.1 Introduction
GV-EV48 is an elevator controller designed to control access of 1 elevator with a maximum
of 48 floors. Up to 2 GV-Readers / GV-GF Fingerprint Readers can be connected to GV-
EV48 using RS-485 connection and network connection. GV-EV48 can recognize
identification cards and grant access to the authorized floors only.
6.1.1 Main Features
• Grant access to specific elevator floors using access cards, card’s PIN code or
fingerprints
• GV-EV48 – 24 Floors: Built-in 24 relay outputs to support up to 24 elevator floors
• GV-EV48 – 48 Floors: Built-in 48 relay outputs to support up to 48 elevator floors
• Support up to 2 GV-Readers / GV-GF Fingerprint Readers through network connection
and RS-485 connection
6.1.2 Packing List
• GV-EV48 – 24 Floors / 48 Floors
• Power Adaptor 12V DC / 3A
• Power Cord
• Battery Cable
• Screw x 8
• Hex Nut x 8
• Hex Pillar x 8
• Micro SD Card 2 GB
• Software CD
• Warranty Card