User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
Installing on a Network
129
7
5. In the Device Name field, keep the default setting or change it to match that of the GV-
ASManager.
6. Click Submit to send the information to the LocalDDNS Server. When the setting is
complete, the Status field will indicate: Register Success. Then the controller can be
accessed with the device name.
Note:
1. The default value of Device Name is user. If more than one controller is connected to
the GV-ASManager, assign each controller a different device name.
2. To access the Device Name on GV-ASManager, open the Controller Setup dialog box,
and select LocalDDNS in the Network drop-down list.
Figure 7-6